Litho press L100A
An exceedingly heavily built full-size lithographic press with hydraulic printing action. This press will effortlessly handle stones up to a size of 95 x 130 cm (paper size 100 x 160 cm).The hydraulic system with two-way hand-pump and large dial readout allow you to set identical pressures time and again. The beech wood surface comes with a 6 mm-thick rubber layer with a 2 mm-thick galvanized steel plate in order to reduce the risk of stone breakage.
The electrical power train with frequency regulator allows for both manual and semi-automatic operation. The low-voltage remote control allows for continuous control of pressure.
All possible safety provisions (EC approval in accordance with the Machine Directive) have been implemented.
This machine is also available with manual drive (model L 100 HM)
|
|
|
|
|
|
|
| Technical data |
|
| L100A | |
|---|---|
| Length | 3000 mm |
| Width | 1250 mm |
| Height | 1800 mm |
| Bedplate | 1000 x 1600 mm |
| Weight | 800 Kg |
| Solid steel roller diameter 150 mm on SKF bearings | |
| Feed | 230 Volt - 3,6 Amp Command on 24 V low voltage 24 Volt |
| Max. pressure |
250 BAR |